Omega-vehicle-security TJ-USB Manuel d'utilisateur Page 11
- Page / 20
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Software
3
3-5
3.3 USB Driver Installation
To install the USB software drivers that are required for your TJ-USB probe to
operate correctly follow these procedures.
You need to have the User Software CD that was supplied with your probe loaded
into the CD drive on your PC.
1. Connect your TJ-USB probe to your computer. You should get a notice box
that indicates that your computer “Has Found New Hardware”
2. Your computer will then launch the Found New Hardware Wizard. Follow
the instructions indicated on the Wizard boxes and the additional
instructions noted in this manual with each box.
After completing the Found New Hardware Wizard your system will ask that you
repeat this process. This is normal. You should repeat the steps outlined here
twice. After the second driver is installed you should then get the “New Hardware
Ready For Use” notice.
Figure 9. Welcome To The Found New Hardware Wizard Screen
From this box you should check the “No, not at this time” button. Then click the
“Next >” button to continue with the driver installation process.
NOTE:
NOTE:
- User’s Guide 1
- Table of Contents 3
- List of Figures 4
- Section 1 - Introduction 5
- Section 2 – Hardware 6
- Section 3 – Software 7
- “Close” button 10
- 3.3 USB Driver Installation 11
- Software 12
- Figure 13. Main Tab Screen 13
- Figure 14. Graph Tab Screen 14
- 4.0 Specifications 18
- WARRANTY/DISCLAIMER 19
- RETURN REQUESTS/INQUIRIES 19
- Shop online at omega.com 20
Edimax Technology Two-console 16 port PS/2 KVM Switch podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Akcesoria komputerowe Edimax Technology Two-console 16 port PS/2 KVM Switch.
Dostarczamy 1 pdf podręczników Edimax Technology Two-console 16 port PS/2 KVM Switch do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Commentaires sur ces manuels