Omega-vehicle-security OMEGAFLEX FPU500 Manuel d'utilisateur télécharger pdf (Page 37)

Troubleshooting Guide

7-3

Problem Solution

Motor will not turn 1. Make sure the tubing is loaded

properly. The tubing should be

centered in the middle of the rollers.

Reload if necessary.

2. Check to see if the motor is turned

on.

3. Check motor fuse.

Motor will not turn – 1. Make sure the tubing is loaded

overcurrent condition properly. The tubing should be

centered in the middle of the rollers.

2. Make sure the tubing wall thickness

is correct (refer to Table 9-1).

3. The tubing durometer may be too

high for the pump (refer to Chapter

9).

4. The tubing may be caught on the

bottom roller. Reposition the roller

slightly and load the tubing again.

The pump will not stay on the 1. The pump is not properly mounted

motor to the motor. Refer to Section 3.

2. The mounting screws are loose.

Tighten the screws, if necessary.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Pas de commentaire

Omega-vehicle-security OMEGAFLEX FPU500 Manuel d'utilisateur Page 37