Omega Vehicle Security Wireless Sensor System zSeries Manuel d'utilisateur télécharger pdf (Page 24)

4.1 iConnect Software

The Coordinator may also be assigned an IP Address by using the iConnect software.

a) Download the iConnect software from the website listed in this manual.

b) Install iConnect software on a networked PC. This software is compatible with

Windows 95, 98, NT, 2000, and XP.

c) Use iConnect to assign an IP address to the Coordinator and access its web pages

for configuration. You can also use any standard web browser to access the zSeries

system’s web pages. Consult with your IT department for obtaining an IP address.

Figure 4.2 Assigning an IP Address using iConnect

1) Place the IP address in this box.

2) Take the MAC address from the label attached to the bottom of the Coordinator and

place it in this box.

3) Click here to send the above IP address to the Coordinator.

4) After the IP address is assigned to the Coordinator, click here to access it’s web

pages.

5) Click here to Ping the Coordinator whose IP address is shown in the IP address

box.

6) Click here to find all the

Coordinator

s on your network .

7) The IP addresses for the Coordinators found by the iConnect will be listed here.

8) These fields indicate the IP address and the subnet mask of the PC on which the

iConnect is running.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

Pas de commentaire

Omega Vehicle Security Wireless Sensor System zSeries Manuel d'utilisateur Page 24