Omega Vehicle Security OMP-MODL Manuel d'utilisateur télécharger pdf (Page 31)

3... INTERFACE MODULES

USING THE OMP-MODL 3-7

ML-BATT; BATTERY PACK MODULE

The OMP-MODL can be equipped with the ML-BATT module to provide battery

power for portable or remote site applications. The ML-BATT module includes two

holders, each of which contains 3 D-cells, resulting in a nominal 9Vdc supply to the

OMP-MODL. The ML-BATT module fastens to the bottom of the MLCPU-1 module

with 4 side screws. A pigtail and polarized connector facilitate quick connection to

the mating connector provided on the MLCPU-1 module (Figure 3... -6).

Field Installation of the ML-BATT Module

Upon receipt of the module, examine the unit and insure that the batteries

are firmly seated in their holders. The ML-BATT module fastens to the

bottom of the MLCPU-1 module with 4 machine screws. The batteries must

be installed (Figure 3... -5) with the positive terminal toward the holder end

marked with a red washer.

Remove the existing back plate installed on the OMP-MODL by removing

the 4 side screws and gently sliding the back plate off of the MLCPU-1

module. This back plate will be replaced by the ML-BATT module and is no

longer required.

A foam spacer is provided to help hold the batteries in their holders. A slot

is cut in the foam spacer. Route the wire pigtail extending from the MLCPU-

1 through this slot. Connect the polarized connector on the end of the wiring

pigtail in the ML-BATT module to the mating connector on the MLCPU-1

module.

RED (+) POLARITY MARKERS

Battery Connection Pigtail

Alkaline D-Cells ( 6 )

(retaining tubes not shown)

ML009

ML-BATT Module

+ + +

+++

Figure 3... -5: ML-BATT Battery Pack Module

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 296 297

Pas de commentaire

Omega Vehicle Security OMP-MODL Manuel d'utilisateur Page 31