Omega-vehicle-security FPU5-MT-110 Manuel d'utilisateur télécharger pdf (Page 59)

Figure 6-10. Schematic of Auxiliary Out Circuit

1. Connect the circuit shown to the Auxiliary Out terminals with the motor stopped.

2. Press the START/STOP key. The motor starts, and the LED in the circuit goes off.

3. Press the START/STOP key. The motor stops, and the LED in the circuit lights

up.

6.6.2 Auxiliary In (Remote Start/Stop)

The Auxiliary In function allows you to remotely start and stop the pump motor.

The Auxiliary In terminals are located near the bottom, on the back of the pump

motor, next to the Auxiliary Out terminals.

1. Momentarily short the Auxiliary In V+ terminal to the Auxiliary In Ground

terminal. The pump starts. The display enters the RUNNING Display

Mode.

2. Momentarily short the Auxiliary In V+ terminal to the Auxiliary In Ground

terminal. The pump stops. The display enters the STOPPED Display Mode.

The momentary shorting action may be achieved with proper TTL or CMOS

circuitry.

Aux Out V+

Aux Out Gnd

9Volts

–

500Ω

LED

Operating the Pump Motor in the RUNNING Display Mode

6-22

NOTE

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 82 83

Pas de commentaire

Omega-vehicle-security FPU5-MT-110 Manuel d'utilisateur Page 59