Omega-vehicle-security Wireless Sensor System zSeries Manuel d'utilisateur télécharger pdf (Page 14)

2.1d Parts of the End Device (zED-DC-H2)

1 8 position DIP switch (under cover), sets the NID and DID of the End Device

(see Section 2.6 for details)

2 Power Switch

3 Label for Unit Address, Group No. and Network ID Address (NID)

4 Wall mounting holes

5 Label with model and serial numbers

6 Radio module firmware revision location on label

7 Case’s tray, where the PCB is mounted

8 Case’s cover

9 Transmit blue LED (under cover)

10 One Screw attaching Cover

11 External probe/sensor through cable gland (shown for -TC option only),

or quick disconnect connector .

Refer to Figure 2.2b for connector configurations.

12 Low Power Input, through cable gland connector

13 Antenna Mount

14 Thermocouple Input removable terminal block connector

(under cover, for -TC option only)

15 LCD Display (for units with -LCD option)

16 Low Power terminal block connector (under cover)

17 Cable Clamp for Thermocouple wiring (under cover)

Figure 2.1d Parts of the End Device (zED-DC-H2)

Warning:

the following parts are

ESD sensitive.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 91 92

Pas de commentaire

Omega-vehicle-security Wireless Sensor System zSeries Manuel d'utilisateur Page 14