Omega-vehicle-security Wireless Sensor System zSeries Manuel d'utilisateur télécharger pdf (Page 30)

2.7.3 DIP Switch Setup: Ethernet - Coordinator

Figure 2.9 Ethernet - 4 Position DIP Switch Setup

To set the Coordinator to factory default settings:

1) Slide DIP switch #2 to ON position.

2) Power the Coordinator on and wait about 10 seconds until the Coordinator

fully boots up.

3) Set the DIP switch #2 back to OFF position (it does not matter if the

Coordinator is powered ON or OFF, just make sure that the DIP switch is set

to OFF, otherwise, every time the unit is power-cycled the factory settings will

take over).

OFF ON

1 SERIAL

2 DEFAULT

3 DHCP

4 TERMINAL

OFF

(Shown in

"OFF" Position)

1) N/C

2) To change Ethernet settings

to factory default

3) To enable/disable DHCP

4) N/C

Coordinator

Rear View

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 91 92

Pas de commentaire

Omega-vehicle-security Wireless Sensor System zSeries Manuel d'utilisateur Page 30