Omega-vehicle-security Wireless Sensor System zSeries Manuel d'utilisateur télécharger pdf (Page 24)

2.4f Disassembly - End Device (zED)

You may need to open the unit for one of the following reasons:

• To turn on Power Switch.

• To mount unit to wall. Refer to Figure 2.2b for mounting dimensions.

• To connect or replace the two 1.5 Vdc AA alkaline batteries, (note the polarity of

batteries).

• To access programming connector.

Remove Cover as shown below, by pressing sides of cover to release latches.

Figure 2.4f Disassembly of the End Device (zED)

COVER

LATCH

SENSOR

BOARD

EXTERNAL

SENSOR/

PROBE

TRAY

POWER SWITCH

BATTERY CLIPS

LATCH

DIP SWITCH

MOUNTING SCREW

PROGRAMMING

CONNECTOR

AA ALKALINE

BATTERIES

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 91 92

Pas de commentaire

Omega-vehicle-security Wireless Sensor System zSeries Manuel d'utilisateur Page 24