Omega-vehicle-security OMP-MODL Manuel d'utilisateur télécharger pdf (Page 63)

3... INTERFACE MODULES

USING THE OMP-MODL 3-39

Each switch bank should have only ONE switch ON and the other four

switches OFF.

CAUTION: The switch banks may have different numbering than the circuit

board... insure that the marking on the circuit board is followed... not the

marking on the switch banks.

Hardware Input Configuration Switches:

No hardware input configuration switches are provided on the MLIM-4. All

configuration is done via the HyperNet software.

Software Configuration of the MLIM-4

The MLIM-4 module is completely configured on a channel by channel basis

from within the HyperNet software. This software configuration and

utilization of the various MLIM-4 channels in a Program Net is covered in

overview in Chapter 6, within the Master Icon Listing in Appendix A, and with

specific detail in this document.

When the MLIM-4 module is detected in a OMP-MODL after clicking on the

New Program button from within HyperNet, four icons representing the

MLIM-4 input channels will display on the screen. The icons will display as

2-wire RTD inputs as the default. These icons can be switched to

Resistance or Thermistor inputs by double-clicking on the icon to open the

configuration dialog then on the Change button.

ml051

Module 3

Module 2

Module 4

Module 5

Module 6

OFF - ON OFF - ON OFF - ON

Module Address (Layer) Switch banks

Figure 3... -27: Example Address setting for Module Layer Position 4

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 296 297

Pas de commentaire

Omega-vehicle-security OMP-MODL Manuel d'utilisateur Page 63