Omega-vehicle-security OMP-MODL Manuel d'utilisateur télécharger pdf (Page 97)

5... HYPERCOMM™ COMMUNICATIONS

USING THE OMP-MODL

5-10

Clear Button Icon (logger Clear not PCMCIA Clear)

When the logger is not Enabled, double-clicking on this button

results in a clearing of memory (after confirmation). After double-

clicking, a dialog will appear to confirm the action. Memory Status

can always be confirmed with the Status Query command (below).

The logger memory can be cleared while the logger is Enabled.

However, If the logger is Enabled, only memory containing data that

has been downloaded will be cleared. This allows for logger use in

long duration continuous acquistion and download periods without

missed data.

Unit Name and ID Query

Each logger can be assigned an ID and short Name. The ID and

NAME are retained in logger memory until changed via the

following procedure and are not cleared with power down or Memory

Clear commands. On loggers equipped with ML-DISP module both

entries can be displayed on the LCD under the STATUS menu and

are also available via a logger Status Query from the PC

(following).

To program the logger ID and NAME, move the cursor over the LCD

icon on the logger and double-click. A dialog will open for editing.

OK will reprogram the logger to the new ID and NAME.

Status Query

At any time, the logger can be interrogated for its operational Status.

Drag and drop the Status Icon from the logger to the PC and release

it. The Logger Status dialog (Figure 5... -6) will open detailing

operational information.

Figure 5...

-5: Status

icon

Figure 5... -6: Logger Status report dialog

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 296 297

Pas de commentaire

Omega-vehicle-security OMP-MODL Manuel d'utilisateur Page 97