Omega-vehicle-security OMP-MODL Manuel d'utilisateur télécharger pdf (Page 55)

3... INTERFACE MODULES

USING THE OMP-MODL 3-31

MLIM-2; DIGITAL INTERFACE MODULE OVERVIEW

Overview:

The MLIM-2 Interface Module provides four input channels and four output

channels on a single module. Each of the four input channels can be

individually programmed for any combination of Event input, Count input, or

Frequency input. The four output channels provide current limited nominal

5VDC output. Configuration of the module is done from within HyperNet in

HyperWare.

Module Installation:

Refer to the Installation Section earlier in this chapter for detailed installation

instructions of the Interface Module onto the System Base.

I/O Module Layer Requirements / Limitations:

The MLIM-2 module can be installed in any of the five I/O Module positions

(Figure 3... -4). The module layer address must be set on the module to

correspond to the layer position into which the module is installed.

This address is programmed into the module through the use of the Module

Address Switch bank (Figure 3... -17). The switch bank contains 5 switches.

Note the marking on the circuit board identifying address rows for Module

Layers 2 through 5. Set one switch in the bank ON corresponding to a

ml051

Module 3

Module 2

Module 4

Module 5

Module 6

OFF - ON

Module Address (Layer) Switch bank

Figure 3... -17: MLIM-2 Module Address Switch Bank

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 296 297

Pas de commentaire

Omega-vehicle-security OMP-MODL Manuel d'utilisateur Page 55