Omega-vehicle-security OMP-MODL Manuel d'utilisateur télécharger pdf (Page 90)

5... HYPERCOMM™ COMMUNICATIONS

USING THE OMP-MODL 5-3

TIP: If the port number is unkown, select one of the

ports then attempt to connect (see following). If

unsuccessful, change the selected Port and try again.

After selecting the port, click on the CONNECT button to initiate

communication with the logger. At this time, HyperWare will attempt to

communicate with the logger . During establishment of the connection, the

OK button will gray and when successful, it will return. Close the SERIAL

COMMUNICATIONS dialog box by clicking the OK button and HyperWare will

return to the HYPERCOMM window ready for communication.

If the link fails ( a dialog will display indicating failure) , check the following:

♦ Is the cable connected?

♦ Is the Omega Engineering supplied adapter used?

♦ Insure that the adapter used is the one that was supplied

with the logger. (other Omega Engineering products use

other similar looking but funtionally different adapters)

NOTE: LBI supplied adapters are wired for proper

compatibility between the logger and the PC. If an

alternatively sourced adapter is used, insure that it

complies with the wiring specified in Appendix I.

Also, adapters that convert DB-25 to DB-9 (and vis-a-

versa) commonly cause problems. Utilize the proper

adapter supplied with the logger (both DB-9 and DB-25

are supplied).

♦ Is the logger power ON?

♦ Select another PC serial port from within the SERIAL

COMMUNICATIONS dialog box and retry.

ESTABLISHING A TELEPHONE MODEM LINK

Modem Hardware Configuration:

Before attempting a link to a logger via telephone modem, insure the

following equipment requirements are met:

Ρ The logger must have an MLIM-5-2400 or MLIM-5-144 module installed.

This modem is referred to as the remote modem in this manual.

Ρ The PC must have a Hayes compatible modem installed or connected

and powered. This modem is referred to as the local modem in this

manual.

Ρ Info on the PC modem capabilities must be on hand (ie Baud rate

capabilities, installed port, etc)

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 296 297

Pas de commentaire

Omega-vehicle-security OMP-MODL Manuel d'utilisateur Page 90